help re-connecting pressure stat

cssharkey

New member
Joined
May 7, 2005
Messages
9
Reaction score
0
I have a LaPavoni BarV2. I disconnected the P-stat and contactor/relay after my P-stat blew. I got a new P-stat (after figuring out it wasn't a bad contactor). So the problem is: I lost my notes on which wire went where, and I need to hook up my P-stat and contactor again - and I have no idea which wire goes where. I have no electrical diagrams and can't get them from the importer. Local tech is not returning my calls for over two months. I'm running with a loaner right now at my shop, but need to return that soon. Any idea where to turn next? Or can someone out there help?
Thanks!
 
Hahaha been down that road before... its okay though. The pressure is nothing more then a on/off switch. Most of the time there are 2 sets of 2 wires but some times three. Essentially though the wires are coming from the power source and enter the pressure stat. Then another set leave the pressure stat and connect to one side of the element.
 
Back
Top Bottom